#### 9.34.1 RX Options

The Renesas RX port of `as` has a few target specfic command line options:

`-m32bit-doubles`
  This option controls the ABI and indicates to use a 32-bit float ABI. It has no effect on the assembled instructions, but it does influence the behaviour of the ‘`.double`’ pseudo-op. This is the default.

`-m64bit-doubles`
  This option controls the ABI and indicates to use a 64-bit float ABI. It has no effect on the assembled instructions, but it does influence the behaviour of the ‘`.double`’ pseudo-op.

`-mbig-endian`
  This option controls the ABI and indicates to use a big-endian data ABI. It has no effect on the assembled instructions, but it does influence the behaviour of the ‘`.short`’, ‘`.hword`’, ‘`.int`’, ‘`.word`’, ‘`.long`’, ‘`.quad`’ and ‘`.octa`’ pseudo-ops.

`-mlittle-endian`
  This option controls the ABI and indicates to use a little-endian data ABI. It has no effect on the assembled instructions, but it does influence the behaviour of the ‘`.short`’, ‘`.hword`’, ‘`.int`’, ‘`.word`’, ‘`.long`’, ‘`.quad`’ and ‘`.octa`’ pseudo-ops. This is the default.

`-muse-conventional-section-names`
  This option controls the default names given to the code (.text), initialised data (.data) and uninitialised data sections (.bss).

`-muse-renesas-section-names`
  This option controls the default names given to the code (.P), initialised data (.D_1) and uninitialised data sections (.B_1). This is the default.

`-msmall-data-limit`
  This option tells the assembler that the small data limit feature of the RX port of GCC is being used. This results in the assembler generating an undefined reference to a symbol called `__gp` for use by the relocations that are needed to support the small data limit feature. This option is not enabled by default as it would otherwise pollute the symbol table.

`-mpid`
  This option tells the assembler that the position independent data of the RX port of GCC is being used. This results in the assembler generating an undefined reference to a symbol called `__pid_base`, and also setting the RX_PID flag bit in the e_flags field of the ELF header of the object file.

`-mint-register=`num
  This option tells the assembler how many registers have been reserved for use by interrupt handlers. This is needed in order to compute the correct values for the `%gpreg` and `%pidreg` meta registers.